Page 1 of 1
[done] Target line - is it possible to add a bearing to a target?
Posted: Sat Jun 20, 2020 7:59 pm
by Ingensor
Hi again!
You can add to a target line azimuth of the target? (screenshot)
Re: Target line - is it possible to add a bearing to a target?
Posted: Sun Jun 21, 2020 8:19 am
by Psyberia-Support
Instead of "Target" use the
Measure tool, you'll have the azimuth.
You can add an
custom menu item to access this tool very quickly.
Re: Target line - is it possible to add a bearing to a target?
Posted: Sun Jun 21, 2020 9:43 am
by Ingensor
Yes, I know the tool "Measure tool", but it is not convenient, if I climb over the rubble of the trees at night. (Often hands dirty) Since I use a real compass with the phone (phone compass is often not accurate), I would love to get the phone, turn on my phone on the lock screen through AlpineQuest check with the current azimuth of the target and move on, without any extra clicks (as long as I look at the azimuth in the status bar, but it is the small size. And if you increase the size of the status bar, they cover the entire map)
Re: Target line - is it possible to add a bearing to a target?
Posted: Sun Jun 21, 2020 10:16 am
by Psyberia-Support
Re: Target line - is it possible to add a bearing to a target?
Posted: Sun Jun 21, 2020 1:57 pm
by Ingensor
Thanks you! Sincerely!
Re: Target line - is it possible to add a bearing to a target?
Posted: Thu Sep 24, 2020 7:55 am
by Ingensor